Non-woven wallpaper is also called non-woven paper wallpaper is a kind of high-grade wallpaper / wallpaper, due to the use of natural plant fiber non-woven process to make stronger pull, more environmentally friendly, not moldy yellow, good breathability is the main quality wallpaper Substrate.
Non-woven wallpaper stickers:
1, Wall treatment
The wall surface is required to be flat, clean and dry, and the color is uniform and uniform. There should be no gaps, uneven embossing defects, and the wall surface should be treated with a base film (or varnish) before construction.
2, Wallpaper cutting
According to the wallpaper's serial number, set the wallpaper, measure the height of the wall, and reserve 5 cm according to the height of the wall to cut the wallpaper. Remember to cut a roll of wallpaper at a time to prevent quality problems.
3, Brush wallpaper glue
The non-woven wallpaper glue must be evenly brushed on the wall, the thickness can be 2mm, and the glue should not be directly brushed on the back of the non-woven fabric, and it should not be soaked in water. Unlike other wallpapers, non-woven fabrics should be thicker and thicker than other wallpapers, reducing their fluidity.
4, Wallpaper
The non-woven wallpaper is posted in a good order in advance.
5, Construction wallpaper cutting
It is necessary to set up the edge to cut the construction. The specific method is to lap the edge during construction. The number of laps depends on the pattern, about 3 cm. The plain color non-woven fabric is applied by the method of positive and negative stickers during construction. After ensuring the pattern alignment, use a ruler to press at the overlap to cut, try to avoid cutting at the corner, so as not to cause the wallpaper to be curled at the corner, ensure the cutting edge is sharp when cutting, no burrs At the same time, pay attention to the strength of the lower knife, to ensure that one cut, one cut, but not too much damage to the surface of the wall.
6, After the wallpaper is cleaned
If there is dust on the surface after the construction, apply a short brush or tweezers, and do not use a wet towel to wipe up the pollution.
Note on non-woven wallpaper:
1. After the base coating coating is dried during construction, draw a vertical line as a standard to prevent the wallpaper from being pasted incorrectly.
2. Do not use hard scraper or nylon brush after the wallpaper is on the wall. Use a soft brush to scrape from top to bottom, smooth the surface of the non-woven fabric, remove air bubbles and wrinkles, and do not scrape the glue out of the joint to avoid pollution. If the glue is squeezed out, immediately wipe it off with a dry towel. Keep your hands clean as much as possible during construction.
3. During construction, inspection should be carried out while construction is completed. If problems are found, the construction will be stopped immediately, and the causes and solutions will be found.